Tanyaradzwa Magudu

• Designed and wired power and control circuits for water treatment projects, ensuring process efficiency. • Programmed PLCs using Ladder Logic for seamless automation of pump control systems. • Installed and configured various ultrasonic and radar level controllers for accurate level measurement and pump control. • Carry out bench testing of electrical and mechanical equipments to detect defects after repairs. • Undertake detailed RCA on component failures, generating and implementing modifications and improvements to address reliability and performance issues within the plant. • Assist mechanical department in carrying out repairs and breakdowns

• Conducted routine inspections of diesel generators and electrical equipment, ensuring optimal performance and safety. • Executed preventive maintenance strategies that reduced equipment breakdowns by 30%. • Troubleshot electrical circuits using advanced testing tools, enhancing repair efficiency. •Carry out insulation resistance test on electric motor to evaluate the integrity of the electrical insulation and to prevent potential short circuits, current leakages, or failures in critical systems. • Coordinated weekly SHE meetings to promote safety and compliance within the team.

• Provide technical support in Industrial Instrumentation and control systems. • Assist in HMI programming and graphics animations using easybuilder 8000 software. • Work with various types of PLCs mainly Mitsubishi Fx series, delta dvp and siemens s7 300 series. • Circuit design and panel wiring according to client specifications. • Diagnose and make changes to PLC logic to suite production requirements. • Create program backups i.e upload and download logics. • Attend to breakdowns as well as performing repairs as per computerized maintenance management systems (CMMS). • Installation and configuration of wide variety of VSD and softstarter ranging from 0.75kw-200kw such as Danfoss VLT aqua drive and Weg CFW11 series. • Carry out in-situ and bench calibration of wide variety of process instruments that record, indicate, control and regulate flow, level,temperature and pressure. • Replacement of faulty sensors such as resistance temperature detectors, thermocouple, positioner, inductive, photoelectric, limit switches. • Provide feedback to the Foreman on the execution of work for continuous improvement of work methods, standardization and planning. • Service boiler controls for optimal performance. • Assist in loop checks and commissioning plant instrumentation.

• Maintenance, installation, test and measure Electrical and Instrumentation equipment’s. • Completed preventive and corrective maintenance and repair to keep equipment running at peak performance. • Servicing and resetting Atlas Copco FX 19 Air dryer and compressor GA250. • Control valve servicing and overhaul ,calibration, valve stroking, replacing worn-out diaphragms, pecking and mounting new positioner . • Wire and configure PID controllers such as siemens DR20/22 , Mod30ml and yokogawa UT35A for flow, level, pressure and temperature measurement as well as on/ off control systems. • Working with Siemens software (Simatic) S5 and S7 • Daily plant checks. • Documentation of plant maintenance and repairs. • Maintain good housekeeping keeping on the work place