Rupak R B.

I need to take care of different types of hydraulic cylinder enquiry. It starts from begining i.e. enquiry receiving from customer, GA drawing preparation, customer approval/comments, preparation of detail drawing, complete cylinder calculation, solving shop-floor problems.

This job profile was same as my current working profile.

My working profile is depicted below : After receiving the order from customer my job gets started, i.e. detail verification of intake order, preparation of mechanical linear actuator assembly drawing, send it to customer for approval & preparation of detail drawing after approval receiving. Mainly i work on mechanical side rather than the hydraulic side (e.g.mechanical & chemical properties of different materials, overall designing criteria, seal selection/selection criteria based on the working condition e.g temperature, pressure, piston speed, surface roughness of honned tube with proper weaviness of internal surface, working fluid medium etc.)