Hugh Thomas Davis

Engineer III & Project Supervisor @ EnSafe

About

I have graduated from the State University of New York at Buffalo in 2019, with a bachelor’s of science in civil engineering. With my past experience focused on construction, inspection, and engineering, I have a broad base of work experience including training new hires, developing site plans, creating cost estimates, writing technical reports, and running finite element analysis. Currently I am a Engineer II with Ensafe where my primary focus is on the development of site plans with the use of Civil 3D.

Country

United States

City

Irving

Industry

Civil Engineering

Skill

Civil Engineering, Autodesk Civil 3D, Project Management, AutoCAD, Technical Writing, Communication, Presentation Skills, Finite Element Analysis (FEA)

Experience

Engineer III & Project Supervisor

EnSafe

2022-7 - Present · 4 yrs 3 mos

Farmers Branch, Texas, United States

Strong focus on producing site plans for oil and gas waste repositories with Auto-CAD Civil 3D. Site plans designed and drafted to be compliant with Rail Road Commission regulations. Significant experience with grading and drainage design including sites over hundreds of acres in Auto-CAD Civil 3D. Performed analysis of waste repository fill rate based on bi-monthly aerial surveys. Upon the completion of waste repositories closure construction drawings, I oversaw the construction of the repositories as junior project manager. Collaborated with a team to develop permits for oil and gas waste repositories for the Rail Road Commission of Texas.

Engineer III & Project Supervisor

EnSafe

2022-6 - Present · 4 yrs 4 mos

Irving, Texas, United States

Structual Engineer I

General Dynamics Electric Boat

2021-8 - 2022-7 · 1 yr

Collaborated with multiple disciplines and departments to complete engineering evaluations. Presented recommended design changes with cost vs benefit framework. Strong experience with structural plans and significant experience with finite element analysis, as well as performing technical writing and analysis on a daily basis

Civil Engineer I

Rielly Engineering

2021-1 - 2021-8 · 8 mos

Monticello, New York, United States

Primary focus was producing site plans for land development with Auto-CAD Civil 3D. These plans showed drainage, stormwater mitigation, soil grading, sewer/water pipe layout and subdivision layouts. Surveying to located property boundaries, wetlands and building positions to be used in Auto-CAD, as well as cost estimates for pavement, sidewalks, curbing, signage, pipe and earthwork

Staff Engineer

Tectonic Engineering Consultants, Geologists & Land Surveyors, D.P.C.

2020-2 - 2020-9 · 8 mos

Newburgh, New York, United States

Created structural analysis reposts for rooftop antenna mounts, primarily focused for the NYC area. Models created for analysis with RISA-3D, with as-builts and field notes to match existing conditions. Specifications followed were, ASCE 7-05 LRFD & ASD wind loads, 2014 NYC Building Code, TIA-222 Rev G, used for NYC analysis. Familiarized with connections checks for HILTI Connections HY-20, HY-70, HY-270, as well as fillet and groove weld, callouts for roof generator platforms.

Engineering Technician

Advance Testing, A SOCOTEC Company

2019-5 - 2020-2 · 10 mos

Campbell Hall, New York, United States

I worked as an engineering technician in the field providing test results to laborers/operators, as needed. Compaction tests were performed on soils around utilities, foundations, and retaining walls to assure conformance to required specifications at large and small job sites. Concrete tested for slump/air/temp on foundations, footings, piers, and walls. Technical writing for daily reports was required. Familiarized with structural plans for buildings and retaining walls