Fernando González

• Conducted, Researched and Completed a de-installation on a General Electric MRI diagnostic imaging system. • Performed functional system inspections and repairs of X-Ray Machines, Ultrasound and wiring MRI Machine. • Responsible for ensuring excellent customer service and administrative responsabilites insuring proper usage. • Basic Troubleshooting, improvement, maintance and service repair needed on refurbished medical equipment. • Managed and configured nodes for a Brightspeed GE 16, Philips CT and MRI for a PACS Synapse system in a Clinic in Mexico. • Team leader on staging a Mammograph Senograph 2000 General Electric, calibration and serviced the unit. • Assisted a Senior Engineer on loading the Software on a Siemens Image Systems Arcadis ( M420) C-Arm. • Preventive Maintance on a GE Benneth Rad Room, MXT8000 Philips CT Scanner, Philips Intera Achieva, Mammograph,Senograph GE.

• Develop Acceptance Test Procedure for a High Voltage Board Special Test Equipment Communication Satellite RF system. • Ordered and tracked electronic component parts to design specializedtest equipment for spacecraft products. • Design a Command/Telemetry STE to level converter box harness on the Linear Driver Amplifier. • Maintain Test Procedures for board and box level testing using oscilloscope, data aquisition and spectrum analyzers. • Generate Functional Failure Mode and Effect Analyses (FFMEA) for Special Test Equipment. • Maintained test and develop RF payload and V band Communication Test Sets for Space Vehicles.

• Continuous Wave Drive testing analysis and network bench marking to ensure service quality antenna signal. • Operated the RF and fiber related test equipment, passive intermodulation analyzer, signal generator and fusion splicer. • Conducted field work and survey poles measurement safety procedures for system wireless. • Performed installations and debugging protocol testing for networking and communication devices. • Maintained Wireless Network division, developing products for digital radio and switching technology.

Collaborative Project: Unmanned Ground Vehicle(UGV) and Unmanned Air Vehicles (UAV). Phase 2 Sponsored by Northrop Grumman Corporation. • Researched, Developed, Tested and Evaluated the UGV Motor Control Unit throughout the project life cycle. • Served as team leader and assigned weekly tasks to team members toward project completion. • Developed design criteria for network interface, circuit design, and sensor fusion. • Designed and assembled the printed circuit boards for the sensors, power management and motor controller. • UGV and two UAV joint network; search and rescue operation. • Onboard computer and microcontroller on UAV to fir mission specifications. • Established wireless communication from the ground station to the UAV and UGV. • Assembled the power management board using PIC microcontroller to prioritize power for electronic components.