Engr. Md Imran Hossain

 Work as project in charge for EPC base installation work cogeneration power plant with Steam turbine and exhaust gas boiler.  Operation of cogeneration power plant with steam turbine and EGB boiler.  Mechanical and electrical installation of Gas generator and EGB boiler at cogeneration power plant project.  Mechanical and electrical installation of HVAC system with EGB and VAM chiller.  Study electrical drawings and properly apply at installation.  Study Mechanical drawings (P&ID, Isometric) and properly apply at installation.  Making Project Time schedule (PTS) and reports for project installation.  Installation and commission of Water treatment plant and ventilation system.  Working as safety in charge at project installation site.  Perform electromechanical installation gas and diesel generator captive power plant.  Perform maintenance work of Cogeneration project using EGB boiler & steam turbine.  Perform pre-commissioning activities and keep documents for gas generator,diesel generator, chiller and boilers.  Installation and calibration of pressure transmitter (PT),flow transmitter (FT),Level transmitter (LT), pressure sensor and temperature element.

 Installation and Commissioning process of Caterpillar Engine (D3512B), Control system (CDVR and Terberg control system), Water separator (Diesel), Water treatment plant, Switchgear (ABB, Vacuum Circuit Breaker), Transformer system (0.6/11 KV, 11/132 KV, 11/0.4 KV).  Erection of Fuel system, Exhaust gas system, Air ventilation system, Compressed air system (10 bar), Lube oil drainage system.  Installation process of a sub-station and its components such as Current transformer (CT), Potential transformer (PT), Insulation system, Buchholz Relay and various protection systems (SF6 circuit breaker, Earth fault relay, ACB, VCB, OCB, Earthing).  Build a good concept about cooling system, turbo charger, alternator, diesel engine basics and various auxiliary components of a 100 MW Power Plant.  Installation of Transmission cable, Control cable, Protection cable  Normal operation such as ON, OFF, Load control and Power factor control of caterpillar engine.  Maintenance services including parts installation and general maintenance activities of standard Caterpillar engine.  General Troubleshooting of Caterpillar engine with Terberg control system, Switchgear and Transmission line.